DataMan 280 Series Resources

Top Frequently Asked Questions

Watch this video to learn about troubleshooting connection issues

Watch this video to learn how to access the DataMan Setup Tool through Windows Firewall

Watch this video to learn how to set up a local PC as a NTP Server

To upload a configuration from a backup (configuration) file to a DataMan reader, do the following:

  1. Disconnect from the camera intended to be restored. To ensure closure it may be easier to close out of the DataMan Setup Tool (DMST) application and restart the software. 
  2. From the DMST’s homepage, go to the Restore section on the left-hand column by clicking on it. 
  3. At the top of the screen there is a Configuration File section with a text box and another box to the far right with 3 dots. Click the 3 dots. Navigate to the location of the backup file to be uploaded to the camera. Highlight the file then click OK.
    NOTE: It may be necessary to change the file type above the OK button if the desired backup file type does not show up. 
  4. Highlight the reader or readers to be restored and click Restore on the lower right. A window will popup showing the progress.
  5. Once the file has been successfully uploaded to all the readers the "Cancel" will change to a "Close" status.
  6. Close out of the window. This concludes the restoration process, and the camera is now restored with the backup file. 

If a DataMan reader has been configured to be on the wrong network subnet, the DMST will not be able to detect and connect to the reader unless the PC system (DMST installed) is connected to the same subnet. There is no way to determine exactly what subnet a DM was configured to be on. If the DM’s subnet is not known, it will need to be factory reset.

To reset the DM back to factory defaults, do the following:

  1. Disconnect the power I/O cable from the DataMan.
  2. Hold down the trigger button while reconnect the power I/O cable. 
  3. Continue to hold the trigger button until you see the status LED flash red and green alternately, and there will be a quick succession of beeps.

The device should now be factory reset.


  • A factory reset will force the camera to use DHCP for its network settings.
  • The above instructions only work on Dataman that have a physical trigger button and a removable power cable.

Top DataMan 280 Resources


Join MyCognex